Fujitsu PRIMERGY RX100 S7 - Inch HDD;SSD Subsystem; 7 Hard Disk Drives; Solid State Drives; Equipping the 2.5-Inch HDD;SSD Bays

RX100 S7 Upgrade and Maintenance Manual 145
Hard disk drives / solid state drives
7.1 2.5-inch HDD/SSD subsystem
7.1.1 Equipping the 2.5-inch HDD/SSD bays
Figure 65: Equipping the 2.5-inch HDD/SSD bays
– Solid state drives (SSDs) are always equipped before installing hard disk
drives.
– If only one HDD/SSD module is installed, the HDD/SSD module will be
installed in position 1. Free bays must be equipped with a dummy module.
– Installing different capacities, install the biggest capacity first.
– Installing different rotating speed, install the fastest rotating speed first.
SAS connectivity
HDD/SSD naming scheme
I The HDD/SSD numbering as listed in the ServerView RAID Manager
differs from the HDD mounting order:
Controller Channel Connection
SAS controller
in slot 1
1 Drives 1, 2, 3, 4
2.5-inch HDDs/SSDs
Bay
RAID
Manager
#
Channel
log.
Drive #
Bay
RAID
Manager
#
Channel
log.
Drive #
1 [0] 102[1] 20
3 [2] 114[3] 21
Table 5: HDD naming scheme
/ 0
1 2