Fujitsu PRIMERGY RX100 S7 - Replacing the BBU Cable; Required Tools; Preliminary Steps

RX100 S7 Upgrade and Maintenance Manual 425
Cables
16.10 Replacing the BBU cable
V CAUTION!
Follow the safety instructions in chapter "Important information" on
page 43.
16.10.1 Required tools
● Preliminary and concluding steps: tool-less
● Main steps: Phillips PH00 / (+) No. 00 screw driver
16.10.2 Preliminary steps
Ê Perform the following procedures:
1. "Opening the rack door" on page 59
2. "Locating the defective server" on page 55
3. "Shutting down the server" on page 59
4. "Extending/removing the server from the rack" on page 60
5. "Opening the server" on page 64
Field Replaceable Units (FRU)
Average task duration: 10 minutes