Fujitsu PRIMERGY RX100 S7 - Preliminary Steps; Removing the Riser Module 1; Required Tools

RX100 S7 Upgrade and Maintenance Manual 209
Expansion cards and backup units
9.4.3.1 Required tools
● Preliminary and concluding steps: tool-less
● Main steps: tool-less
9.4.3.2 Preliminary steps
Ê Perform the following procedures:
1. "Opening the rack door" on page 59
2. "Disabling BitLocker functionality" on page 75
3. "Shutting down the server" on page 59
4. "Extending/removing the server from the rack" on page 60
5. "Opening the server" on page 64
9.4.3.3 Removing the riser module 1
Figure 122: Removing the riser module 1
Ê Carefully pull out the riser module 1 upward.