Fujitsu PRIMERGY RX100 S7 - Installing the Riser Module 1; Concluding Steps

342 Upgrade and Maintenance Manual RX100 S7
Management and diagnostics modules
14.3.3.12 Installing the riser module 1
Ê Install the riser module 1 as described in section "Installing the front LAN
card" on page 332.
14.3.3.13 Concluding steps
Ê Perform the following procedures:
1. "Closing the server" on page 66
2. "Installing the server in the rack" on page 68
3. "Switching on the server" on page 72
4. "Enabling BitLocker functionality" on page 94
5. "Closing the rack door" on page 73