Fujitsu PRIMERGY RX100 S7 - Installing the Riser Module 2; Concluding Steps

434 Upgrade and Maintenance Manual RX100 S7
Cables
16.10.12Installing the riser module 2
Figure 323: Installing the riser module 2
Ê Insert the riser cards into the system board slots.
16.10.13Concluding steps
Ê Perform the following procedures:
1. "Closing the server" on page 66
2. "Installing the server in the rack" on page 68
3. "Switching on the server" on page 72
4. "Closing the rack door" on page 73