Fujitsu PRIMERGY RX100 S7 - Installing an Expansion Card Slot Bracket

184 Upgrade and Maintenance Manual RX100 S7
Expansion cards and backup units
9.2.1.2 Installing an expansion card slot bracket
Ê Place the controller on the mounting tabs on the slot bracket.
Ê Fasten the slot bracket to the controller with two M3 x 4.5 mm screws.
I Use the low profile bracket perforated for the ModularRAID controllers
based on LSI MegaRAID.
Figure 92: Perforated and non-perforated slot brackets
I For examples see the next sections.
1 Full height bracket non-perforated
2 Full height bracket perforated
3 Low profile bracket perforated