Fujitsu PRIMERGY RX100 S7 - Installing the New RAID Card Cable

388 Upgrade and Maintenance Manual RX100 S7
Cables
16.1.5 Installing the new RAID card cable
Figure 264: Connecting the RAID card cable (example 2.5-inch SAS/SATA backplane)
Ê Connect the RAID card cable to the SAS/SATA backplane:
– SGPIO connector to connector J2
– SATA connectors to connectors SATA1, SATA2, SATA3, SATA4
according the color coding
I In the 3.5-inch configuration the red and blue SATA connector is not
used.
Figure 265: Connecting the SGPIO cable to the system board
Ê Connect the free end of the SGPIO line to the connector "BP SGPIO" on the
system board.