Fujitsu PRIMERGY RX100 S7 - Installing the BBU in the Holder

RX100 S7 Upgrade and Maintenance Manual 431
Cables
Ê Connect the BBU cable to the BBU.
V CAUTION!
Make sure that the connector side with the three dots is on the top (see
close-up). Otherwise you risk short-circuits.
16.10.9 Installing the BBU in the holder
Figure 320: Installing the BBU in the BBU holder (A)
Ê At a slight angle, fit the BBU under the right retaining bracket on the BBU
holder (1).
Ê Fold down the BBU until it locks in place (2).