11.3 Replacing the heat sink
V CAUTION!
Follow the safety instructions in chapter "Important information" on
page 43.
11.3.1 Required tools
●
Preliminary and concluding steps: tool-less
●
Main steps:
– Phillips PH2 / (+) No. 2 screw driver
– lint-free cloth
11.3.2 Preliminary steps
Ê Perform the following procedures:
1. "Opening the rack door" on page 59
2. "Locating the defective server" on page 55
3. "Shutting down the server" on page 59
4. "Extending/removing the server from the rack" on page 60
5. "Opening the server" on page 64
11.3.3 Removing the riser module 1
Ê Remove the riser module 1 as described in section "Removing the riser
module 1" on page 281.
Field Replaceable Units (FRU)
Average task duration: 15 minutes
To Next Page
Loading...
