Fujitsu PRIMERGY RX100 S7 - Installing the Front VGA;LAN Module; Connecting the Front VGA Cable to the System Board

330 Upgrade and Maintenance Manual RX100 S7
Management and diagnostics modules
14.3.1.5 Installing the front VGA/LAN module
Figure 221: Installing the front VGA/LAN module
Ê Thread the free ends of the cables through the bay.
Ê Push the front VGA/LAN module into the bay from the front (1) until the
locking mechanism engages (2).
14.3.1.6 Connecting the front VGA cable to the system board
Figure 222: Connecting the front VGA cable to the system board
Ê Connect the front VGA cable to the system board connector "FRONT VGA".
/
0