Fujitsu PRIMERGY RX100 S7 - Disconnecting the Cables; Removing the Defective 2.5-Inch SAS;SATA Backplane

156 Upgrade and Maintenance Manual RX100 S7
Hard disk drives / solid state drives
7.1.5.3 Disconnecting the cables
Figure 71: Disconnecting the cables from the 2.5-inch SAS/SATA backplane
Ê Disconnect the following cables from the SAS/SATA backplane:
– (1) power cable from connector J4
– (2) SGPIO cable from connector J2
– (3)-(6) SAS/SATA data cables from connectors SATA1, SATA2, SATA3,
SATA4
For the cable plan see section "Cabling" on page 462.
7.1.5.4 Removing the defective 2.5-inch SAS/SATA backplane
Figure 72: Removing the 2.5-inch SAS/SATA backplane
Ê Pull the SAS/SATA backplane upward until the bolts disengage (see circles).
Ê Take out the SAS/SATA backplane.
1
2
0
3
4 5