RX100 S7
Upgrade and Maintenance Manual 383
System board and components
21.If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller
(expansion card or onboard).
The following notes are required for RX100 S7p (PYR10Pxxx for
Japanese market).
I Configuration of network settings should be performed by the
customer. For further information, please refer to section "Note on
network settings recovery" on page 375.
22.If applicable, restore LAN teaming configurations as described in section
"After replacing the system board" on page 98
23."Closing the rack door" on page 73
To Next Page
Loading...
