Matrix ETERNITY NE - Page 187

Matrix ETERNITY NE System Manual 177
through the GSM network. To know more about this feature, see the description for “Automatic Number
Translation”.
To apply Automatic Number Translation (ANT) on the trunk,
1. Click [+] Automatic Number Translation to expand.
2. Select the desired ANT Table number, table 1 to 8, which you want to apply on the trunk. Default: OFF.
3. Configure the ANT table number you selected.
4. Click ANT link. A new window opens.
5. Click the Table Number you selected for this trunk.
The selected table appears on your screen.
The table has two columns: one for Dialed Number Strings and the other for the corresponding Substitute
Number strings. The number strings are stored against an Index number, from 1 to 32. You can to enter as
many as 32 number strings.
6. Enter the Dialed Number strings and their corresponding Substitute Number strings in the respective
columns. Enter the Dialed Numbers and their corresponding Substitute Numbers against each Index
number. For example, if '95' is entered as the Dialed Number at Index 01 and its Substitute Number '91'
must be entered at Index 01.
7. Click Submit to save your entries.
8. Close the window.
SMDR Storage
The Station Message Detail Recording (SMDR) feature of ETERNITY enables you to record the details of Internal,
Incoming (IC) and Outgoing (OG) calls made from/to all its trunks and extensions. To obtain SMDR as a report, you
must enable SMDR Storage, and set filters. See “Station Message Detail Recording (SMDR)” and “Station
Message Detail Recording–Storage” to know more.
1. Click [+] SMDR Storage to expand options.
2. To store details of incoming calls landing on this trunk, select the check box Store Incoming Calls.
Default: selected.
3. To store details of outgoing calls made from this trunk, select the check box Store Outgoing Calls.
Default: selected.
4. Click Submit.