68 Matrix ETERNITY NE System Manual
Pre-requisites
System resources (number of trunk and extension ports supported) vary by configurations of ETERNITY NE. It is
common for system resources to be used below capacity in a first-time installation.
To make the task of configuring easier and more focussed, ETERNITY allows you to define System Pre-requisites:
the system configuration you are using (NE2, NE3, NE4, NE6), the number of trunk and the number of extension
ports you want to configure. Accordingly, Jeeves will show only as many trunk and extension ports that you have
specified.
To configure,
1. Click the Pre-requisites link.
2. Enter Customer Name. Default: Blank.
Customer Name is the name of the organization/enterprise using ETERNITY NE.
The Customer Name you enter in this field will appear as header on the various System Reports generated
and printed by the ETERNITY NE like SMDR Incoming, Outgoing and Internal Call Reports, Alarm Status
reports, etc.
The Customer Name may consist of a maximum of 80 alphanumeric characters, including punctuation
marks. So, you can enter also the organization's address along with the Customer Name.
3. Enable On-Site Configuration, if you want Basic Settings pages to display only those port types and ports
that are on-board (connected). Default: Disabled.
To Next Page
Loading...
