270 Matrix ETERNITY NE System Manual
SMTP Settings
You can use the VMS to send emails for the following functions:
• notification to the extension users about the arrival of new messages (Refer Email based Notification).
• System Alerts to the System Engineer (USB memory full).
For email transmission, the VMS uses Simple Mail Transfer Protocol (SMTP). If you intend to use Email Based
Notification and send System Alerts to the System Engineer, you must:
• configure the parameter Message Wait Notification via Email
73
in the VMS settings of the extension.
• configure the parameter System Alerts through Email and SE Email ID in the VMS General Parameters.
• configure the SMTP Settings.
To configure SMTP Settings,
• Log in as System Engineer.
• Enter Full Programming Access mode.
• Click the link VMS Configuration.
• Click the link SMTP Settings to open the page.
• Configure the SMTP parameters:
73. You can also have the new voice message mailed as an attachment with the message wait notification.
To Next Page
Loading...
