Matrix ETERNITY NE - I;O Debug

Matrix ETERNITY NE System Manual 917
To debug a single port, define the Start and End Port numbers as the same.
• In the Debug field, select Enable to start Port State debug.
I/O Debug
• Select the Port Type for which you want to debug I/O communication:
•DKP
•CO-SLT
•VoIP
• Mobile
• Door Phone
•VMS
• In the Start Port field, enter the number of the selected Port Type from which the system should start
debugging.
• In the End Port field, enter the number of the selected Port Type after which the system should end
debugging.
If you want to debug a range of ports, configure the starting and ending port numbers in the Start Port and
End Port fields.
To debug a single port, define the Start and End Port numbers as the same.
• In the Debug field, select Enable to start I/O debug.
• Click Submit button to save Debug settings.