210 Matrix ETERNITY NE System Manual
SIP100rel
This parameter is to be configured if you want to support reliable transmission of (SIP) provisional responses and to
use PRACK (Provisional Acknowledgement).
1. To enable SIP 100rel, select the check box Use 100rel. Default: disabled.
SIP Over TCP
ETERNITY NE supports transporting of SIP messages over User Datagram Protocol (UDP) as well as Transfer
Control Protocol (TCP) connection. Despite the advantages that SIP over TCP offers, it is more common to use
UDP to transport SIP messages. To receive SIP messages over TCP,
1. Select the check box Enable SIP over TCP. Default: Enabled.
To be able to send SIP messages over TCP, you must configure 'TCP' or 'TCP (Fallback to UDP)'.
SIP/RTP Ports
1. Enter the SIP UDP Port address.
This port defines the port on which the ETERNITY listens for SIP messages transported over UDP. This
port is also used as the source port for sending SIP messages to the remote peer. The valid range for this
port is 1024-65535. Default: 05060.
2. Enter the SIP TCP Port address.
This port defines the port on which the VoIP Port of ETERNITY listens for SIP messages transported over
TCP. This port is also used as the source port for sending SIP messages to the remote peer. The valid
range for this port is 1025-65535. The default SIP TCP Port is 05060.
3. Enter the RTP Listening Port address. This port defines the port on which the VoIP Port of ETERNITY
listens for RTP Packets. This port is also used as the source port for sending RTP packets to the remote
peer. The valid range for this port is 1024-65278. The default RTP Listening Port is 08000.
To Next Page
Loading...
