Matrix ETERNITY NE - Configuring LCR Type on Trunks

638 Matrix ETERNITY NE System Manual
• Click the Service Provider Based link to open the page.
• Enter the values of the Service Provider-based LCR you prepared on the sheet of paper in the appropriate
fields.
• Click Submit at the bottom of the page to save your settings.
Configuring LCR Type on Trunks
After assigning Cost Factor to Trunks and configuring the LCR Type - Time-based, Number-based, Time and
Number-based, Service Provider-based - you must now apply the desired LCR Type on the Outgoing Trunks
selected for the extension types: SLT, DKP, SIP.
• Under “Basic Settings”, open the link to the Extension type:
• “SLT Extensions”
• “DKP Extensions”
• “SIP Extensions”
• Select the desired Extension number, for example SLT 201.