Matrix ETERNITY NE System Manual

Matrix ETERNITY NE System Manual 493
Removing a participant from a Multiparty Conference
Any participant, who has a DKP or Extended IP Phone can remove another participant from the conference.
To remove E from the conference,
• A goes ON-Hook, then goes OFF-Hook.
• A dials the feature code to remove party from the conference.
• A selects E from the list of participants that appear A’s DKP/Extended IP Phone and presses Enter Key.
• E is disconnected.
Withdrawing from a Multiparty Conference
Participants in a conference can exclude themselves by dialing a feature code.
If the conference has been initiated from the DISA mode, the caller (remote user) must dial the code for
withdrawing from the conference.

If participant goes ON-Hook, without dialing the feature code for withdrawing from a Multi-party
Conference, the participant will be included in the conference again, when the participant dials the
Conference inclusion feature code (191). To avoid this, participants must dial the feature code for
Withdrawing from conference.

If all participants of a Multi-party Conference have withdrawn from the conference, one-by-one, but the
none of them have dialed the feature command to terminate the conference (190), the system will start the
'Release Conference if idle for more than (Minutes) Timer'. This Timer is programmable, and by default it is
set to 002 Minutes. On the expiry of this Timer, the system will free the resource occupied by the
conference on the conferencing circuit.
Canceling a Conference
Any participant in a conference can dial the Cancel conference code (190) to end the conference, all participants
will get Error Tone and the system resource occupied by the conference will be freed.
How to configure
For this feature to work,
• the feature 'Conference' must be enabled in the“Class of Service (COS)” of the extensions. By default, this
feature is enabled on all extensions, so all extensions can use this feature. See “SLT Extensions”, “DKP
Extensions”, “SIP Extensions” under “Basic Settings”.

The feature 'Conference' in the Class of Service also includes 3-Party and Multi-party Conference.
Extensions that are denied 'Conference' in their Class of Service will not be allowed Multi-party as well as
3-Party and Dial-In Conference.
• If desired, you may also change default value of the Release Conference if Idle for more than (min) Timer.
See “System Timers and Counts”.

Matrix ETERNITY NE Specifications

General

Brand	Matrix
Model	ETERNITY NE
Category	PBX
Language	English