Matrix ETERNITY NE - Send CLI; Anonymous Calls; Debug; Forced Account Code

Matrix ETERNITY NE System Manual 205
• Click Submit.
• Close the window.
See “Time Tables” to know more.
Send CLI
1. To hide the subscriber number of the mobile port from being displayed to the called party, select the check
box Do not send CLI for all Outgoing Calls.
This feature will work only if subscribed/supported by your mobile service provider.
Anonymous Calls
1. To allow incoming calls without CLI to land on the mobile port, select the check box Accept Incoming
Calls without CLI.
Debug
1. To initiate debug for the mobile port, select the check box Enable Debug. Default: Disabled.
Forced Account Code
1. To apply the Forced Account Code feature on the mobile trunk, select the check box Do not allow
Outgoing Calls without Account Code (Forced Account Code). Default: Disabled.
When you enable this flag, the system will prompt extension users to dial the Account Code whenever
they grab this trunk to dial out a number. The system will allow extension users to dial out numbers only
after they have dialed the Account Code or Name.
Account Codes feature must also be enabled in the Class of Service of extension users who are to be
allowed this feature. See “Account Codes” to know more about this feature.
Now that you have finished configuring the Mobile trunk. You may configure the next Mobile trunk.
1. Click the tab of the next Mobile trunk number.
2. Follow the same steps as described above to configure this trunk.
3. Use the Copy button to apply the same Mobile trunk settings you configured on this trunk.