Matrix ETERNITY NE - Ethernet WAN

28 Matrix ETERNITY NE System Manual
Before you connect the system to WAN, we recommend that you first connect a computer to the Network Port of
ETERNITY NE, configure the Basic Settings, and then connect to WAN.
• You can connect ETERNITY NE to WAN either over Ethernet port (Ethernet WAN) or over Mobile Port 1 or Mobile
Port 2 (Wireless WAN).
While several installation scenarios are possible, only three most common and most typical scenarios are depicted
here.
Ethernet WAN
• Use the RJ45 Ethernet cable supplied for the Network port of ETERNITY to connect the system to the IP network,
which may be Public Internet or a LAN.
If connecting to the Public IP Network,
• Plug one end of the RJ45 Ethernet cable into the Network Port of ETERNITY and the other end into the Broadband
Router/Modem.
If connecting to a Private Network (Behind a NAT Router),
• Plug one end of the RJ45 Ethernet cable into the Network Port of ETERNITY and the other end into the LAN
Switch/Hub.