Matrix ETERNITY NE - Debug Settings; VMS Debug; Voip Ethernet Port Debug

Matrix ETERNITY NE System Manual 915
Debug Settings
• Select the Debug Port to which you want to send the debug. Default: Ethernet.
• In the Syslog Server IP Address: Port field, enter the server address and the port number. Default: port
number 514.
• Now select the events/processes which you want to debug:
•Port State
• I/O
• Configuration Transfer
•Error
• Communication Manager
• File Open/Read/Write
•VMS
• ACB
• Maturity/AOC
• Auto-upgradation/RCOC
VMS Debug
• In the Syslog Server IP Address: Port field, enter the server address and server port number where the
debug log is to be sent. Default: port number is 514.
• Select the application/processes you want to debug: VMS Application, SMTP, Configuration Transfer
VoIP Ethernet Port Debug
• Select the Enable Debug check box to send debug to the Syslog server.
• In the Syslog Server Address field, enter the server address and server port number where the debug log
is to be sent. Default: port number is 514.
• Select the desired Debug Level from the following supported by ETERNITY NE:
• Serial
•SIP
• CALL
• Registered User
• Registered Trunk
•BLF/MWI
•Media
•VoPP
• Call Advance
• Registered User Advance
• Registered Trunk Advance
• BLF/MWI Advance
• Media Advance
• Presence
•IM
The debug log will be generated for the options you selected. For example: if debug log of Call is required,
enable 'CALL' level and disable all other debug levels.