Matrix ETERNITY NE - Configuring Using a Telephone; Entering the SE Mode Using a Telephone

58 Matrix ETERNITY NE System Manual
Configuring using a Telephone
A few parameters of ETERNITY NE may be configured by dialing the relevant command strings from a telephone.
The telephone may be any Single Line Telephone (SLT) or the Matrix proprietary Digital Key Phone (DKP), or the
Extended IP Phone, connected as an extension of the ETERNITY NE.
For the ease of operation, you may use a DKP/Extended IP Phone instead of an SLT. Using a DKP/Extended IP
Phone has the advantage that
• you can view the command strings that you have keyed in on the phone’s display;
• you will get prompts and confirmatory messages on the phone's LCD display, in addition to confirmation
tone played to you.
• you dial alphanumeric command strings.
All these facilities will not be available to you on an SLT.
You can enter the System Engineer as well as the System Administrator mode to configure the system using a
telephone.
It is possible to configure the ETERNITY NE from any location using a Telephone. You can use a
Telephone connected as an extension of the ETERNITY NE to configure the system On site (where it is
installed).
You can also configure the system using a Telephone Off site, i.e. from a Remote location, using the
“Direct Inward System Access (DISA)” feature of the ETERNITY NE. You can access both the System
Engineer mode as well as the System Administrator mode from the remote location.
System Engineer Mode
At the System Engineer level, can be done by dialing command strings referred to in this document as SE
Commands or System Commands. SE Commands are unique to the feature/facility being configured.
Entering the SE mode using a Telephone
The telephone that you use to enter the SE mode may be a DKP or an SLT connected as extension phone of the
ETERNITY NE.
To enter the SE mode via a DKP/SLT:
•Dial 1#91-SE Password
6
• You get programming tone to indicate entry into the SE mode.
• Now, dial the desired SE Command to configure.
• You get confirmation tone and message on the LCD if using EON.
To exit the SE mode:
•Dial 00.
• You will hear the dial tone of the ETERNITY NE.
6. You may use the default SE password, 1234, if the password has not been changed already. If the password has been changed,
use the new password.