Matrix ETERNITY NE System Manual 39
Wireless WAN
• Connect SETU VP248, the Extended IP Phone, or any standard IP Phone to the LAN Switch.
• You may also register any SIP device on the public network as SIP Extension.
Connecting SETU VP248 as Extended SIP Extension
You are recommended to complete the following steps before connecting the Extended IP Phone to ETERNITY NE:
• Decide the location of the Extended IP Phone—within the same network or outside—according to your
installation scenario.
• Log into the web-browser Jeeves. Read the topic “Configuring using the Web-based GUI: Jeeves” under
Configuring ETERNITY NE for instructions.
• Configure DHCP Server on the “Network Parameters” page under Basic Settings of Jeeves.
• Assign an extension number to the Extended IP Phone on the “Extension Numbering Plan” page under
Basic Settings of Jeeves.
• For the SIP extension number you assigned to the Extended IP Phone, configure these parameters on the
“Matrix Extended IP Phone Settings – Location 1” page of Jeeves:
• Enable Matrix Extended IP Phone Mode.
• Enter the MAC Address of the Extended IP Phone.
• Assign the Registrar Server IP Address, as per you installation scenario.
See the topic “SIP Extensions”, under Basic Settings, for instructions.
Now, follow the steps described below to install the Extended IP Phone. The instructions are common for all models
of the SETU VP248. For the purpose of illustration, the premium model, SETU VP248P, has been used.
1. Unpack the SETU VP248 box and verify package contents.
2. Mount the phone on a desk or wall at a location convenient to you.
To Next Page
Loading...
