60 Matrix ETERNITY NE System Manual
Entering SA Mode using a Telephone
You may use a DKP/Extended IP Phone or an SLT extension of the ETERNITY to enter the SA Mode.
To enter SA mode from an extension phone,
•Dial 1#92-SA Password
7
• You get a confirmation Tone of the ETERNITY to indicate successful entry into the SA mode.
• Dial SA Command strings: 1072-Feature Access Code.
• You get a confirmation tone and text message on the phone display (if using EON).
• Replace handset to exit SA mode.
OR
•Dial 1#92
You can exit from the SA mode automatically or manually. To exit the SA mode automatically, you must
configure the SA Mode Timer. This Timer can be set to a desired duration between 000 and 255 minutes.
On the expiry of the set time, the system disconnects the extension phone from the SA mode. By default,
the SA Mode Timer is set to 003 minutes. The Timer is loaded every time a new SA command is issued.
To configure the SA Mode Timer:
•Dial 1072-016-SA Mode Timer
Where,
SA Mode Timer = 000 to 255 minutes.
• You can also exit the SA mode before the SA Mode Timer expires by dialing this command. If the SA
Mode Timer is set to 000 minutes, you can exit the SA mode only by dialing the command 1#92.
The SA Mode TImer can also be configured from the SA pages of Jeeves.
7. You may use the default SA password, 1111, if the password has not been changed already. If the password has been changed,
use the new password.
When you dial this command, the system will check if the facility 'SA Mode' is enabled in the Class of Service allowed to the exten-
sion from which you have dialed this command. If the SA mode is not allowed, an Error Tone will be played. The Error Tone will be
played also when the SA password is entered incorrectly.
If the facility 'Allow SA Commands' is enabled in the Class of Service of the extension you are using, you can skip this step and
directly dial the SA Command (1072-<Command String>).
To Next Page
Loading...
