Matrix ETERNITY NE System Manual 69
When On Site Configuration is enabled, ETERNITY detects the different trunk and extension port types
present in the system (at Power-ON/Reset). Accordingly, all pages of Jeeves display only those ports
detected by the system for configuration.
You can then define the number of ports you want to configure out of the existing port types.
Enable the 'On-Site Configuration?' flag when you are configuring the system at the installation site.
4. Select as Model Type, the configuration of ETERNITY NE that you are using: NE2, NE3, NE4, NE6.
When you select the Model Type, Jeeves displays on relevant pages, the port types according to the
system capacity (the maximum number of ports) supported by your model.
For example, if you selected ETERNITY NE6 as Model Type, the page will show maximum CO Ports as 6,
maximum DKP extensions ports as 2, and maximum SLT ports as 14. If you selected ETERNITY NE2 the
page will show maximum number of ports as 2 for CO Ports, 2 for DKP ports, and 4 SLT ports.
5. Define the Number of Ports Used for each Port Type: CO, DKP, SLT, Mobile, SIP from the respective
combo boxes.
For example, if you want 4 CO Trunks, 1 DKP extension, and 8 SLT extensions to be used, select the
same numbers from the combo box.
If you want to use voice mail, or connect a device (Door Lock Release) to the Digital Output port, select
'Yes'.
If you have enabled On-Site Configuration, the fields for 'Number of Ports Used', will be populated with
exactly the number the system has detected. The fields for port types which are not available on-board the
system are displayed as non-editable fields.
6. Click Submit to the save changes.
To Next Page
Loading...
