Matrix ETERNITY NE - Page 251

Matrix ETERNITY NE System Manual 241
3. To select Outgoing Trunks to route the emergency number double click the Through field.
• A multiple selection box opens. On the left, trunks appear with their names (if configured in “Naming
Trunks”) and port numbers in a sequence, starting with CO trunks, followed by Mobile trunks and SIP
trunks
68
.
• To select a trunk, place your cursor on the desired trunk, and click the Select>> button.
Or
• Press the ctrl key and click the left mouse button to select multiple trunks.
Make sure that the trunks selected for each Emergency number route the Emergency call to the right
network.
You may select as many as 10 trunks. You will get an alert, if you select more than 10 trunks or select
the same trunk more than once.
To change the sequence of the trunks you selected, use the Up and Down arrow buttons on the right
display box.
To delete trunks from the ones you have selected use Delete key on your keyboard.
• Enable Rotation if you have selected more than one trunk. Default: Disabled.
When you enable Rotation, each new outgoing call is routed through the subsequent trunk in the
group,
69
ensuring equal distribution of outgoing call traffic on all trunks.
When Rotation is OFF, calls are routed through the first trunk in the group. If this trunk is busy, the call
is routed to the next trunk in the group.
Rotation has no relevance if only one trunk is selected.
• Click OK. The multiple selection box closes.
68. If you have not assigned any names to the trunks, they will appear with their default names (CO, MOB, SIP) and port numbers. If
you have enabled On-Site Configuration, only those trunks that are connected will appear in the box.
69. The first call through the first trunk, the second through the second, the third through the third trunk, and so forth. Thus each new
call is routed through the trunk next to the one that routed the previous outgoing call.