32 Matrix ETERNITY NE System Manual
• When you mount EON48 on a desk, you can attach the Foot Stand in two ways as illustrated below.
• Connect the handset of the EON48 to the phone body using the spring cord.
• To use a Headset (not supplied with the phone), plug any standard stereo headset with 2.5mm single
connector into the headset jack on the left side panel of the phone.
You can also plug in a headset with RJ11 connector into the Headset port at the bottom of the phone.
3. Connect EON48 to the wall jack. Plug one end of the RJ11 cable into the connector of EON48 labeled as
‘Line’. Plug the other end into the wall jack.
4. When the ETERNITY NE is powered ON, the EON will get reset. The EON communicates with the
ETERNITY. The handshaking lasts for 5-6 seconds. The EON model, version and revision number, along
with the message 'Please wait'… appear on the LCD display.
5. After successful handshaking and reset cycle, if the DKP Parameters have been configured, the LCD
display of the EON will show the extension number and the extension name in a line. The day, date and
time, time zone in the other line.
MATRIX EON48-S V2R2
To Next Page
Loading...
