Matrix ETERNITY NE - Page 640

630 Matrix ETERNITY NE System Manual
• For each Time Zone that you define, select the Trunk with the lowest cost as your first preference, i.e.
Preference 1. Select the trunk of your second, third and fourth preference (in order of increasing cost.
When the trunk you selected as first preference is busy, the system will route the call through the next
trunk you have set that is free.
• Refer to the table you prepared for assigning Cost Factor to trunks.
• For example, you want calls made during 9am to 8pm to be routed through BSNL trunks (CO1 and CO2).
If these trunks are busy, you want the system to route calls through the BSNL mobile trunk. When this line
is busy, you want the system to attempt to route calls through the line of Reliance.
• You want calls made between 8pm to 9am to be routed through BSNL CO1 trunk only.
• At Time Zone Index 1, define the Time Zone start and end time in 24 Hours:Minutes format, enter the Cost
Factor you assigned to CO1 (01) and CO2 (02) as Preference 1 and Preference 2 respectively. Enter the
cost factor you assigned to and as Preference 3 and Preference 4 respectively.
• Similarly, at Time Zone Index 2, define the Time Zone in 24 Hours:Minutes format. Enter the Cost factor
you assigned to CO1, i.e. 01 as Preference 1, 2, 3, and 4. When calls are made during this time period,
they will be routed through CO1 only.
• If you have finished defining Time Zones and the preferred trunks for the time zones, configure the Time-
based LCR using Jeeves.
• Open Jeeves.
• Log in as System Engineer.
• Click the Advanced Settings link.
• Click the Least Cost Routing (LCR) link.
Time Zone
Index
Time Zone Cost Factor
Start Time
(HH:MM)
End Time
(HH:MM)
Preference
1
Preference
2
Preference
3
Preference
4
1 09:00 20:00 01 02 04 03
2 20:01 08:59 01 01 01 01
3
4
5
6
7
8