694 Matrix ETERNITY NE System Manual
The Peer-to-Peer table you configure on ETERNITY would look like this:
• At Location B, you may do a suitable configuration of the PBX.
• With the necessary configuration done at both locations, when an extension user 201 of ETERNITY at
Location A dials 301, the number of an extension of PBX A, the system checks the CUG table to match the
dialed digits with the Route Code and the Dialed Digit Count. As a match is found, it selects the SIP trunk
defined for routing the Route Code, i.e. SIP 1.
• As SIP 1 is set to Peer-to-Peer mode, the system checks the Peer-to-Peer Table configured. It finds a
match for the digit ‘3’ and places the call to the IP Address 121.124.130.1 configured for this number.
How to configure
For instructions on configuring the SIP Trunk parameters for the Peer-to-Peer application—SIP Trunk Mode, Peer-
to-Peer Table, SIP ID, Treat incoming Peer-to-Peer calls as Station, Send CLI—see “SIP Trunks”.
For instructions on configuring the CUG Table, see “Closed User Group (CUG)”.
To configure the Peer-to-Peer Table,
• Open Jeeves.
• Log in as System Engineer.
• Click the Advanced Settings link.
• Scroll to VoIP Configuration under Advanced Settings.
• Click the VoIP Configuration link to expand.
Index Number Domain Address Name
001 No Match Found
002 3 121.124.130.110
Prudent
Mumbai
003
To Next Page
Loading...
