Matrix ETERNITY NE - Page 797

Matrix ETERNITY NE System Manual 787
organization. Refer the above table for default values of each protocol supported by supported by ETERNITY NE.
To refine Handshake Parameters,
• Click SMDR-Posting OG Handshaking Protocol option to expand.
• Configure the following parameters as required:
• Response to ENQ Timeout: The time for which the sender waits for a response to ENQ from the
receiver. Default: 03 seconds.
• ENQ Retry Count - on No Response (to ENQ): The number of times the sender should send ENQ
before dropping the process, in case response is not received for the last message sent.
• ENQ Retry Time - on No Response (to ENQ): The time after which the sender should sent the ENQ
again, in case the response is not received for the last message sent.
• ENQ Retry Count - on Negative Response (to ENQ): The number of times the sender should send
ENQ before dropping the process, in case of a negative response received for the last message sent.
• ENQ Retry Time - on Negative Response (to ENQ): The time after which the sender should sent the
ENQ again.