870 Matrix ETERNITY NE System Manual
• On successful Walk-In, the system applies the Class of Service and Toll Control of extension 301 on
extension 201.
• Extension user A can now dial the trunk access code and the external, long distance number.
• If Extension user A has 'Walk out automatically on completion of call' set as the Walk-Out Mode on
extension 301, A will be walked out when the current call ends or if A goes ON-Hook at any time after
walking in to extension 201.
• If Extension user A has 'Walk out on user request set as the Walk-Out Mode on extension 301, A can walk
out of 201 only by dialing the feature code for Walk-Out.
However, if Extension user A does not walk out by dialing the feature code, the system will walk out A only
when another extension user walks in to extension 201.
• Calls made by Extension user A from extension 201 using Walk-In will be calculated and charged to
extension 301.
• Call record details of calls made by Extension user A from extension 201 using Walk-In will be recorded in
the Station Message Detail Record of extension 301.
At a time, only one extension user can walk in to another extension.
How to configure
This feature is available to all extensions of ETERNITY NE. It does not require any other configuration except
selection of the Walk-Out Mode for the extension in its port parameters.
If you want to allow different walk-out modes to different extensions, then decide which of the extensions are to be
allowed 'Walk out automatically on completion of call' and which are to be allowed 'Walk out on user request'.
To select the Walk-Out Mode for extensions,
• Log in as System Engineer.
• Click the Basic Settings link.
• Click the link of the extension type:
• “SLT Extensions”
• “DKP Extensions”
• “SIP Extensions”
To Next Page
Loading...
