Matrix ETERNITY NE System Manual 893
• Dial 6 to leave message VMS prompts: "Enter the Extension number for which you wish to leave
message." (LeavemsgE.wav)
• Dial the desired extension number VMS prompts: "Record your message after the beep and press #
(hash/pound) to end. (Recmsg.wav)
• If no mailbox is assigned to the dialed extension number, the VMS prompts: "Mailbox not assigned. To
disconnect, press 1. To go to Home Position, Press 0." (NoMailbox.wav)
• Record your message and press # to end recording. The VMS plays back the recorded message and
prompts: To re-record the message press 1, to confirm press 2." (RecAgain.wav)
• If Message Verification is disabled, the VMS does not playback the recorded message and prompts:
"Your message has been recorded", “press # (hash/pound) to end’.
• If the extension you called is busy, you may leave a message for another extension:
It is mandatory for the caller/extension user to terminate the recording by dialing # (or the digit configured).
If recording of the message is terminated simply by going on-hook, the VMS will not terminate the recording
and the call will be disconnected only after time-out, i.e. the Maximum Message Length configured for the
extension.
To Next Page
Loading...
