NEC Electra Elite IPK - Page 292

Electra Elite IPK Document Revision 4
Programming Manual 2 - 215
___________________________________________________________________________________
___________________________________________________________________________________
Page 5
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
Forced
Account Code
/Authorization
Code
Group
Listening
Selection
Station
Relocation
Set Call
Forward – Off
-Premise
Pre-Set
Dialing
Allow/Deny
Live
Monitoring
ANI/Caller ID
Display
Selection
Not Used
Page 6
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
ARS Overflow
VMS
Message
Indication
Unverified for
Forced
Account Code
/Authorization
Code
Not Used
Caller ID for
K-CCIS
Call Monitor
(Originate)
Call Monitor
(Receive)
Saved
Caller ID
missed
call Info.
Page 7
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
Send
Caller ID to
SLT
Not Used
Station Name
Assignment
Hot Key Pad
Interactive
Soft Keys
DNIS Display Not Used Not Used
Programming Procedures
1 Go off-line.
2 Press LK1 + LK8 +
KH to access the Memory Block.
3 Use the dial pad to enter Class No.
 Use the following to enter Class No:
K ~ I to enter numeric data
J to move cursor left
L to move the cursor right
4 Press the corresponding CO/PBX line key to allow or deny the feature selection.
The LED indication changes to indicate data each time CO/PBX line key is pressed.
Press
C to go to the next page.
Press
A to go back to the previous page.
5 Press
G key to transfer data.
6 Repeat Steps 3 and 4 for each Class. The next Memory Block is displayed.
7 Program the next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-8-07
Class of Service (Attendant) Feature Selection 1
CO/PBX
Line Key LED
Off On
Data Deny Allow