NEC Electra Elite IPK - Page 390

Electra Elite IPK Document Revision 4
Programming Manual 2 - 313
___________________________________________________________________________________
___________________________________________________________________________________
1-13-04 PRT B Channel Outgoing Priority
Selection
General Description
Use this Memory Block to assign the Outgoing Priority for the B-channels when calls
are originated on a PRT(1)-U( ) ETU.
This assignment is allowed by handset programming and SAT.
Display
Settings
 Notes 
LK 1LK 2LK 3LK 4LK 5LK 6LK 7LK 8
The shaded
selection is the
default.
H → L
High to Low
L → H
Low to High
Programming Procedures
1 Go off-line.
2 Press LK1 + LK13 +
KD to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
4 Press
G to write the data. The next Memory Block is displayed.
5 Program the next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
7-1
Card Interface Slot Assignment
1-13-00
PRT Channel Assignment
1-13-01
PRT Signal Format Selection
1-13-03
Call by Call Service Selection
1-13-05
PRT B Channel-to-Trunk Group Assignment
5-06
Trunk Group Outgoing Priority Selection
This Memory Block applies to all firmware versions of the PRT(1)-U( ) ETU.
System Mode
1
Submode
13
Data No.
04
PC Programming
¦ +AN
0 1 / 0 4 : C H S L C = H > L
T I M E D I S P L A Y
Data
No.
Setting
Data
PRT
1~8
Title