2 - 346 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
1-15-06 Originating Office Code Number
Assignment
General Description
Use this Memory Block to assign the Office Code to the system when Open
Numbering Plan is used.
Display
Programming Procedures
1 Go off-line.
2 Press LK1 + LK15 +
KF
to access the Memory Block.
3 Use dial pad keys to enter Setting data.
Use the following to enter data:
J
to move cursor left
L
to move cursor right
K
~
I
to enter numeric data
The Maximum Office Code Number can have four digits and should
include the Access Code for the open numbering plan. Valid range is
0~9999.
Default Values
:
Blank
4 Press G to write the data.
5 Press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
7-1
Card Interface Slot Assignment
7-3-01
MIF (LCR) Assignment
7-3-02
MIF (SMDR) Assignment
1-15-00
K-CCIS Main/Remote Office Selection
1-15-01
Common Signal Channel Data Speed Assignment
1-15-02
Common Signal Channel Assignment
1-15-03
Originating Point Code Assignment
1-15-04
Destination Point Code Assignment
System Mode
1
Submode
15
Data No.
06
PC Programming
¦
+AW
0 6 : O F F I C E
T I M E D I S P L A Y
Setting
Data
Data
No.
Title
To Next Page
Loading...
