2 - 362 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
1-15-14 Centralized Day/Night Switching for
Main Office Assignment
General Description
Use this Memory Block to assign the Point Codes and the CCH Channel to control
remote systems for Centralized Day/Night Switching.
A CCH Channel of i can be assigned for K-CCIS over IP (R1500 or higher).
Display
Programming Procedures
1 Go off-line.
2 Press LK1 + LK15 +
AD
to access the Memory Block.
3 Use dial pad keys to enter Table number, CCH Channel, and Point Code.
Press Redial + 1 to assign i for K-CCIS over IP (R1500 or higher).
Use the following to enter data:
J
to move cursor left
L
to move cursor right
K
~
I
to enter numeric data
Point code range is 00001~16367.
Tables 01~16 can be assigned.
Default Values
:
All Tables Not Specified
4 Press G to write the data, and display the next Memory Block.
5 Repeat Steps 3 and 4 for each table. The next Memory Block is displayed.
6 Program the next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
7-1
Card Interface Slot Assignment
7-3-01
MIF (LCR) Assignment
7-3-02
MIF (SMDR) Assignment
1-15-00
K-CCIS Main/Remote Office Selection
1-15-01
Common Signal Channel Data Speed Assignment
System Mode
1
Submode
15
Data No.
14
PC Programming
¦
+AW
1 4 : T 0 1 : = 0
T I M E D I S P L A Y
Data
No.
Point
Code
Table
01~16
CCH
Channel
1~4, i
To Next Page
Loading...
