NEC Electra Elite IPK - Page 440

Electra Elite IPK Document Revision 4
Programming Manual 2 - 363
___________________________________________________________________________________
___________________________________________________________________________________
 Notes 
1-15-02
Common Signal Channel Assignment
1-15-03
Originating Point Code Assignment
1-15-04
Destination Point Code Assignment
1-15-05
Destination Point Code Transfer Assignment
1-15-06
Originating Office Code Number Assignment
1-15-07
K-CCIS Message Response Timeout Assignment
1-15-08
Link Reconnect Allow/Deny Selection
1-15-09
K-CCIS Maximum Call Forwarding Hop Assignment
1-15-10
Calling Name Display Allow/Deny Selection
1-15-11
Centralized Billing Allow/Deny Selection
1-15-12
Centralized Billing – Point Code of Center Office Assignment
1-15-13
Centralized Day/Night Switching for Remote Office Assignment
1-15-15
Centralized BLF Send Point Code Assignment
1-15-16
Centralized BLF Send Extension Number Assignment
1-15-17
Centralized BLF Send Time Assignment
1-15-18
Centralized BLF Display Extension Number Assignment
3-70
CIC Number Assignment
5-05
Common Signaling Channel Route Selection
1-1-05
Start Time Selection
1-5-02
SMDR Print Format
1-5-13
Printer Connected Selection
1-5-14
Printer Line Feed Control Selection
1-5-25
SMDR Valid Call Time Assignment
1-5-26
SMDR Incoming/Outgoing Print Selection
1-8-35
COM Port Baud Rate Setting Assignment
4-56
SMDR Telephone Print Selection
1. Memory Block 1-15-00 (K-CCIS Main/Remote Office Selection) is used for the Centralized Day/Night Switching
feature.
2. This Memory Block is used for the Main Office only.
3. Up to 16 Remote Offices can be controlled by a Main Office.
4. The Electra Elite IPK cannot be a Main Office for a NEAX2000/2400 PBX.
Related Programming (Continued)
M.B. Number Memory Block Name