2 - 374 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
1-15-20 Centralized 911/Calling Party (CPN)
Originating Number Selection
General Description
Use this Memory Block to assign the Electra Elite IPK installed as a Remote K-CCIS
Office to send the Station Number or CES-ID or Calling Party Number for Calling Party
Number information to the Main Office when an Emergency 911 call is originated.
This Memory Block is used at remote offices only.
R2000 or higher is required.
Display
Settings
LK 1LK 2LK 3LK 4LK 5LK 6LK 7LK 8
The shaded
selection is the
default.
STA.
(Station
No.)
CESID
(CES-ID)
Programming Procedures
1 Go off-line.
2 Press LK1 + LK15 +
BK
to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the Setting Data option.
4 Press
G to write the data, and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-8-43
Enhanced 911 Trunk Assignment
1-8-44
Enhanced 911 Alternate Route Assignment
1-8-45
Enhanced 911 Alternate Route Assignment (Maintenance Busy)
1-8-46
Enhanced 911 Dialing Digit Assignment
1-15-19
Centralized 911 Allow/Deny Selection
1-15-21
Centralized 911 Look Ahead Routing Allow/Deny Selection
System Mode
1
Submode
15
Data No.
20
PC Programming
¦
+AW
2 0 : 9 1 1 O R G S T A .
T I M E D I S P L A Y
Data
No.
Setting
Data
Title
To Next Page
Loading...
