NEC Electra Elite IPK - Page 55

1 - 22 Multiline Terminal Programming
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
LK 1 System Mode
LK 5 SMDR/LCR
Data
No.
Memory Block Name Default Value Programming Values
02 SMDR Print Format ALL ALL, MSK
13 Printer Connected Selection NO NO, PC(Future), YS
14 Printer Line Feed Control Selection YS YS, NO
25 SMDR Valid Call Time Assignment 040s 000~990s (in 10-second increments)
26 SMDR Incoming/Outgoing Print
Selection
OUT ALL, OUT, INC
LK 1 System Mode
LK 6 DSS
Data
No.
Memory Block Name Default Value Programming Values
01 Attendant Add-On Console to
Telephone Port Assignment
Refer to 1-6-01 Attendant Add-On Console to Telephone Port
Assignment on page 2-183.
03 DSS Call Voice/Tone Signal
Selection
VOICE TONE, VOICE
05 Attendant Add-On Console Key
Selection
Refer to 1-6-05 Attendant Add-On Console Key Selection on
page 2-185.
07 Message Board Lamp Assignment NON NON (Not assigned)
MSG (message)
08 Attendant Transfer Selection During
Live Record
YS NO, YS