Electra Elite IPK Document Revision 4
Programming Manual 1 - 29
___________________________________________________________________________________
___________________________________________________________________________________
LK 1 System Mode
LK 11 DTI
Data
No.
Memory Block Name Default Value Programming Values
00 T1 Signal Format Selection 24 12 (Superframe), 24 (Extended
Superframe)
01 Clear Channel Selection ZCS ZCS, B8ZS
02 Line Length Selection 1 Refer to 1-11-02 Line Length Selection
on page 2-291.
03 IP K-CCIS Selection NO YS, NO
05 T1 Channel Selection Refer to 1-11-05 T1 Channel Selection on page 2-294.
06 Signaling Selection LS LS, GS
07 DTI Trunk Type Assignment CO CO, E&M, DID, ANI
08 Digits Delete for T1 ANI Assignment 2DGT 0 (No delete), 1~9
LK 1 System Mode
LK 12 ACD/UCD
Data
No.
Memory Block Name Default Value Programming Values
00 ACD/UCD Group Pilot Number
Assignment
Not Specified Any Unused Extension Number
01 ACD/UCD Group Overflow
Destination Assignment
Not Specified Any Unused Extension Number
02 ACD/UCD Overflow Time Selection 60s In seconds: ∞, 10s, 20s, 30s,
60s,120s, 180s, 240s
To Next Page
Loading...
