Planet SGS-6341-24T4X - Page 1097

63-5
63.8 flush disable arp
Command:
flush disable arp
Function:
Disable sending the flush packets of deleting ARP.
Default:
By default, enable the sending function of the flush packets which are deleted by ARP.
Command mode:
ULPP group configuration mode.
Usage Guide:
If configure this command, when the link is switched, it will not actively send the flush packets to
notify the upstream device to delete the entries of ARP.
Example:
Disable sending the flush packets of deleting ARP.
Switch(config)# ulpp group 20
Switch(ulpp-group-20)# flush disable arp
63.9 flush disable mac
Command:
flush disable mac
Function:
Disable sending the flush packets of updating MAC address.
Default:
By default, enable sending the flush packets of updating MAC address.
Command mode:
ULPP group configuration mode.
Usage Guide:
If configure this command, when the link is switched, it will not actively send the flush packets to
notify the upstream device to update the MAC address table.
Example:
Disable sending the flush packets of updating MAC address.
Switch(config)# ulpp group 20
Switch(ulpp-group-20)# flush disable mac