Planet SGS-6341-24T4X - Page 1098

63-6
63.10 flush enable arp
Command:
flush enable arp
Function:
Enable sending the flush packets of deleting ARP.
Default:
By default, enable sending the flush packets of deleting ARP.
Command mode:
ULPP group configuration mode.
Usage Guide:
If enable this function, when the link is switched, it will actively send the flush packets to notify the
upstream device, so as to delete the list entries of ARP.
Example:
Enable sending the flush packets of deleting ARP.
Switch(config)# ulpp group 20
Switch(ulpp-group-20)# flush enable arp
63.11 flush enable mac
Command:
flush enable mac
Function:
Enable sending the flush packets of updating MAC address.
Default:
By default, enable sending the flush packets of updating MAC address.
Command mode:
ULPP group configuration mode.
Usage Guide:
If enable this function, when the link is switched, it will actively send the flush packets to notify the
upstream device, so as to update the MAC address table.
Example:
Enable sending the flush packets of updating MAC address.
Switch(config)# ulpp group 20
Switch(ulpp-group-20)# flush enable mac