Planet SGS-6341-24T4X - Page 1114

66-1
Chapter 66 Commands for RSPAN
Configuration
66.1 remote-span
Command:
remote-span
no remote-span
Function:
To configure VLAN to RSPAN VLAN. The no form of this command will delete the RSPAN VLAN.
Command Mode:
VLAN Configuration Mode.
Default:
Not configured.
Usage Guide:
This command is used to configure the existing VLAN as RSPAN VLAN. Dedicated RSPAN VLAN
should be configured before RSPAN can function. When configuring RSPAN VLAN, it should be
made sure that specialized VLAN, such as the default VLAN, dynamic VLAN, private VLAN,
multicast VLAN, and layer 3 interface enabled VLAN, should not be configured as RSPAN VLAN. If
any existing sessions are still working when RSPAN is disabled, these sessions will be still working
regardless the configuration change. However, if any layer 3 interface is configure in the VLAN after
RSPAN is disable, the existing RSPAN session will be stopped.
Example:
Switch(Config-Vlan5)#remote-span
66.2 monitor session remote vlan
Command:
monitor session <session> remote vlan <vid>
no monitor session <.session> remote vlan
Function:
To configure local mirror session to RSPAN. The no form of this command will restore the RSPAN to
local mirror.
Parameter: