69-3
Usage Guide:
To enable debug switch of displaying NTP event, after that, if some server changed from available
to unavailable or from unavailable to available, the received illegal packet events will be printed.
Example:
To enable debug switch of displaying NTP event information.
Switch# debug ntp events
69.5 debug ntp packet
Command:
debug ntp packet [send | receive]
no debug ntp packet [send | receive]
Function:
To enable/disable the debug switch of displaying NTP packet information.
Parameter:
send: The debug switch of sending NTP packet.
receive: The debug switch of receiving NTP packet.
If there is no parameter, that means should enable the sending and receiving switch of NTP
packet in the same time.
Default:
Disabled.
Command Mode:
Admin Mode.
Example:
To enable the debug switch of displaying NTP packet information.
Switch# debug ntp packet
69.6 debug ntp sync
Command:
debug ntp sync
no debug ntp sync
Function:
To enable/disable debug switch of displaying local time synchronization information.
Default:
To Next Page
Loading...
