Planet SGS-6341-24T4X - Page 393

26-32
Command:
netbios-name-server <address1>[<address2>[…<address8>]]
no netbios-name-server
Function:
Configures WINS servers’ address; the “no netbios-name-server” command deletes the WINS
server.
Parameters:
<address1>…<address8> are IP addresses, in decimal format.
Default:
No WINS server is configured by default.
Command Mode:
DHCP Address Pool Mode
Usage Guide:
This command is used to specify WINS server for the client, up to 8 WINS server addresses can be
configured. The WINS server address assigned first has the highest priority. Therefore, address 1
has the highest priority, and address 2 the second, and so on.
Example:
Setting the server address of DHCP pool “1” to 192.168.1.1.
Switch(dhcp-1-config)#netbios-name-server 192.168.1.1
26.1.22 netbios-node-type
Command:
netbios-node-type {b-node | h-node | m-node | p-node | <type-number>}
no netbios-node-type
Function:
Sets the node type for the specified port; the “no netbios-node-type” command cancels the
setting.
Parameters:
b-node stands for broadcasting node, h-node for hybrid node that broadcasts after point-to-point
communication;
m-node for hybrid node to communicate in point-to-point after broadcast; p-node for point-to-point
node;
<type-number> is the node type in Hex from 0 to FF.
Default:
No client node type is specified by default.
Command Mode: