Planet SGS-6341-24T4X - Page 504

33-143
Default:
Close the debug by default.
Command Mode:
Admin Mode.
Example:
Switch#debug rip redistribute route receive
Switch#no debug rip redistribute route receive
33.7 default-information originate
Command:
default-information originate
no default-information originate
Function:
Allow the network 0.0.0.0 to be redistributed into the RIP. The “no default-information originate”
disable this function.
Default:
Disabled
Command Mode:
Router mode and address-family mode
Example:
Switch# config terminal
Switch(config)# router rip
Switch(config-router)# default-information originate
33.8 default-metric
Command:
default-metric <value>
no default-metric
Function:
Set the default metric value of the introduced route. The “no default-metric” command restores the
default value to 1.
Parameter:
<value> is the metric value to be set, ranging between 1~16.