Planet SGS-6341-24T4X - Page 558

35-197
Example:
To enable debugging of sending command from OSPF process redistributed to other OSPF process
routing.
Switch#debug ospf redistribute message send
35.19 debug ospf redistribute route receive
Command:
debug ospf redistribute route receive
no debug ospf redistribute route receive
Function:
To enable/disable debugging switch of received routing message from NSM for OSPF process.
Parameter:
None.
Default:
Disabled.
Command Mode:
Admin Mode.
Usage Guide:
None.
Example:
To enable debugging switch of received routing message from NSM for OSPF process.
Switch# debug ospf redistribute route receive
35.20 default-information originate
Command:
default-information originate [always | METRIC | METRICTYPE | ROUTEMAP]
no default-information originate
Function:
This command create a default external route to OSPF route area; the “no default-information
originate” closes this feature.
Parameter:
always: Whether default route exist in the software or not, the default route is always advertised.
METRIC = metric <value>: Set the metric value for creating default route, <value> ranges