Planet SGS-6341-24T4X - Page 559

35-198
between 0~16777214, default metric value is 0.
METRICTYPE = metric-type {1|2} set the OSPF external link type of default route.
1 Set the OSPF external type 1 metric value.
2 Set the OSPF external type 2 metric value.
ROUTEMAP = route-map <WORD>.
<WORD> specifies the route map name to be applied.
Default:
Default metric value is 10, default OSPF external link type is 2.
Command Mode:
OSPF protocol mode
Usage Guide:
When introducing route into OSPF route area with this command, the system will behaves like an
ASBR.
Example:
Switch#config terminal
Switch(config)#router ospf 100
Switch(config-router)#default-information originate always metric 23 metric-type 2 route-map
myinfo
Relevant Commands:
route-map
35.21 default-metric
Command:
default-metric <value>
no default-metric
Function:
The command set the default metric value of OSPF routing protocol; the “no default-metric”
returns to the default state.
Parameter:
<value>, metric value, ranging between 0~16777214.
Default:
Built-in, metric value auto translating.
Command Mode:
OSPF protocol mode
Usage Guide:
When the default metric value makes the metric value not compatible, the route introducing still