EasyManuals Logo

Planet SGS-6341-24T4X User Manual

Planet SGS-6341-24T4X
1206 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #595 background imageLoading...
Page #595 background image
36-234
introducing cost is defined with area default-cost command.
Example:
Switch # config terminal
Switch (config)# router ipv6 ospf
Switch (config-router)# area 1 stub
Relevant Commands:
area default-cost
36.4 area virtual-link
Command:
area <id> virtual-link A.B.C.D [instance-id <instance-id> | INTERVAL <value>]
no area <id> virtual-link A.B.C.D [instance-id <instance-id> | INTERVAL]
Function:
Configure a logical link between two backbone areas physically divided by non-backbone area. The
no area <id> virtual-link A.B.C.D [instance-id <instance-id> | INTERVAL]” command removes
this virtual-link.
Parameter:
<id> is the area number which could be digits ranging between 04294967295, and also as an IP
address.
<instance-id> is the interface instance ID ranging between 0~255 and defaulted at 0
INTERVAL= [dead-interval|hello-interval|retransmit-interval|transmit-delay]
<value>: The delay or interval seconds, ranging between 1~65535
<dead-interval>: A neighbor is considered offline for certain dead interval without its group
messages which the default is 40 seconds.
<hello-interval>: The time interval before the router sends a hello group message, default is 10
seconds
<retransmit-interval>: The time interval before a router retransmitting a group message, default
is 5 seconds
<transmit-delay>: The time delay before a router sending a group messages, 1 second by default
Default:
No default configuration.
Command Mode:
OSPFv3 protocol mode
Usage Guide:
In the OSPF all non-backbone areas will be connected to a backbone area. If the connection to the
backbone area is lost, virtual link will repair this connection. You can configure virtual link between

Table of Contents

Other manuals for Planet SGS-6341-24T4X

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Planet SGS-6341-24T4X and is the answer not in the manual?

Planet SGS-6341-24T4X Specifications

General IconGeneral
Switch typeManaged
Switch layerL3
Quality of Service (QoS) supportYes
Form factor1U
CertificationFCC Part 15 Class A, CE
Product colorBlack
Console portRJ-45
SFP+ module slots quantity4
Basic switching RJ-45 Ethernet ports typeGigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity24
Routing entries128
Networking standardsIEEE 802.1D, IEEE 802.1Q, IEEE 802.1ab, IEEE 802.1p, IEEE 802.1s, IEEE 802.1w, IEEE 802.1x, IEEE 802.3, IEEE 802.3ab, IEEE 802.3ad, IEEE 802.3ae, IEEE 802.3u, IEEE 802.3x, IEEE 802.3z
Virtual LAN featuresStacked VLAN, Private VLAN, Tagged VLAN, Protocol-based VLAN
Copper ethernet cabling technology10BASE-T, 100BASE-T, 1000BASE-T
Flash memory16 MB
Internal memory512 MB
Processor frequency400 MHz
AuthenticationMAC-based authentication, Port-based authentication
Security algorithmsSNMPv3, SSH, SSL/TLS
Throughput95.24 Mpps
Jumbo frames9216
Number of queues8
MAC address table16000 entries
AC input voltage100 - 240 V
AC input frequency50 - 60 Hz
Power supply included-
Power consumption (max)19.9 W
Heat dissipation67.91 BTU/h
Storage temperature (T-T)-10 - 70 °C
Operating temperature (T-T)0 - 50 °C
Operating relative humidity (H-H)5 - 90 %
Harmonized System (HS) code85176990
Weight and Dimensions IconWeight and Dimensions
Depth240 mm
Width440 mm
Height43.6 mm
Weight3170 g

Related product manuals